none

Upcoming National Measurement Institute courses

08-11-2010
by 
in 

The National Measurement Institute is conducting two new courses this month based on common industry practices.

The courses include:

Introduction to GD&T 16 November 2010

This one-day course will provide you with a basic understanding of Geometric, Dimensioning and Tolerancing (GD&T). GD&T is an international language that is used on engineering drawings to accurately describe a part.

GD&T uses engineering drawings as a means of communicating information between design, manufacturing and quality inspection. This course is based on common industry practices and the Australian Standard AS1100. It is essential preparation for the two-day Fundamentals of GD&T that will be available in 2011.

Coordinate Measuring Machine (CMM) Level 1 17-18 November 2010

This two-day course combines theoretical knowledge with CMM demonstrations and practical exercises. The aim of these practicals will be to involve participants with developing measuring strategies, as stipulated by the GD&T drawings for various components.

For more information click on the title of the courses above.

Related news & editorials

  1. 16.03.2018
    16.03.2018
    by      In
    In the 1960s, as much as a quarter of Australia’s workforce was employed in the manufacturing sector, and the industry fuelled 25% of the nation’s economy, according to the Productivity Commission. Half a century on, the closure of Toyota, Ford and then General Motors in October 2017 seemed to... Read More
  2. 24.01.2018
    24.01.2018
    by      In
    According to Southern Cross CEO, Mark Ferguson, if Australian industry really wants to get serious about saving energy then it needs to take a close look at ‘two-stage’, air compressor technology. As energy costs continue to outstrip other business input expenses it is critical, more than ever... Read More
  3. Martin Chappell
    03.11.2017
    03.11.2017
    by      In
    With Australia’s manufacturing industry strengthening, leaders and heads of IT are weighing up which new technologies they should implement to gain a competitive edge. Martin Chappell from Motorola Solutions explains how a simpler and more focused use of data can be the best approach.
    Australia’s... Read More
  4. Sahara Force India F1
    29.08.2017
    29.08.2017
    by      In
    The pace of Formula One (F1) development is rivalled only by the speeds achieved on the racetrack. Each time the Sahara Force India F1 Team brings its car to a circuit, it represents the team’s top engineering; every time the team leaves, the car is just a baseline. Between races it must be... Read More