Clear sky
36 °C
Germantown, Maryland
Clear sky

Fri Jul 19 2019
none

TELESCOPIC SCREW COVERS SPRING INTO ACTION

06-06-2019
by 
in 

Telescopic spring covers are typically used in industry to cover machine screws to form mechanical protection, though recent uses have included isolating protein greases from foodstuffs. These helical metal covers surround and protect critical cylindrical mechanisms. Their overlapping coils seal out contaminants while wiping away dirt and debris with each cycle. An equally important use is as a safety barrier to seal off pinch points and other hazards to prevent injury.

The spring action holds the unit in place as it expands and compresses between two parallel surfaces. Simple flanges may be used to position the cover, which is normally installed over the end of a rod, shaft or screw assembly. However, open-wound models are available to be wound onto the rod, shaft or screw without the necessity of partially disassembling the host machine.

Motion Technologies’ telescopic spring covers are made of 1095 polished blue carbon steel and provide long life and maximum protection of rods, shafts and screws from chips and other destructive elements. They are also available in stainless steel for applications subject to rusting or pitting. Sizes range from internal diameters of 7 to 300mm with extended lengths up to 4500mm. Over 2000 custom sizes are available.

Motion Technologies
02 9524 4782
www.motiontech.com.au

Related news & editorials

  1. 19.07.2019
    19.07.2019
    by      In
    Requirements from clients have resulted in the production of 1 x 1m Vesconite Hilube polymer wear plates measuring 25mm and, more recently, 40mm in thickness.
    Vesconite Bearings’ technical sales consultant Eddie Swanepoel has been instrumental in translating clients’ requirements into new extruded... Read More
  2. 19.07.2019
    19.07.2019
    by      In
    The way to a ready-to-connect e-chain is now even quicker and easier with the new online igus e-chain expert. With the aid of this free and accessible online tool, users can design their e-chain systems using a smart phone, tablet or computer. Whether an unsupported, gliding or hanging application... Read More
  3. 19.07.2019
    19.07.2019
    by      In
    Machine or equipment failure causes a lot of trouble for operators: packaging equipment comes to a standstill or a wind turbine no longer turns. igus has therefore developed the world’s first intelligent plain bearing, which detects wear in extremely stressful applications in advance and sends a... Read More
  4. 19.07.2019
    19.07.2019
    by      In
    Deep drilling rigs with top drive systems are used in the oil and gas industry. To guide cables in these systems, manufacturers and operators have so far been using so-called ‘service loops’. However, these often create problems: the cables have no guidance or defined bend radius, and can slip into... Read More