none

MANUAL CALL POINTS ARE SIL2 COMPLIANT

07-12-2018
by 
in 

The STExCP8 range of manual call points are SIL2 compliant to IEC 61508, allowing system integrators greater confidence when designing systems requiring an enhanced safety integrity level.

Made by E2S Warning Signals and available in Australia from Mechtric, these robust devices are part of the comprehensive STEx family of explosion/flameproof audible and visual signalling devices and feature highest grade 316L stainless-steel enclosures.

Designed for installation in the harshest of onshore and offshore environments, the call points and push buttons are IECEx and ATEX approved for use in Zone 1 and 2 hazardous areas for fire and gas alarm systems and emergency shutdown and process control applications. Four different operating mechanisms are available: a break glass call point and three pushbuttons with momentary activation, tool reset latching and dual action manual reset.

The break glass unit employs a plastic-coated glass element for operator safety and an optional stainless steel lift flap is available to prevent inadvertent operation.

Dual M20 cable entries are provided that can be orientated for top or bottom cable entry with a further M20 entry on the side. All unused entries are fitted as standard with stainless-steel blanking plugs.

Mechtric
1800 252 995
www.mechtric.com.au

Related news & editorials

  1. 22.09.2021
    22.09.2021
    by      In
    Leussink, the exclusive Australian distributor of Demmeler 3D Welding table solutions, has expanded its range with the new Demmeler WeldSpace system, a fully equipped welding cell with a built-in welding cobot.
    Leussink’s Managing Director Jason Leussink says the new Demmeler WeldSpace system is... Read More
  2. 22.09.2021
    22.09.2021
    by      In
    In a $600,000 research partnership between AML3D Limited and Deakin University, supported through the Innovative Manufacturing Cooperative Research Centre (IMCRC), experts are developing high strength aluminium – scandium welding wire for Wire Additive Manufacturing (WAM®) applications.
    AML3D, a... Read More
  3. 22.09.2021
    22.09.2021
    by      In
    New Elesa stainless steel hinges in AISI 304 grade join the company’s existing ranges in both 304 and 316 grades, offering high strength for heavy doors as well as excellent corrosion resistance.
    These are especially suited to enclosure installations in arduous environments, such as pharmaceutical... Read More
  4. 20.09.2021
    20.09.2021
    by      In
    Lateral restraint blocks made of an engineering plastic that typically retains most of its strength over 100 years are being produced by Hercules Engineering to safeguard suburban and highway concrete bridges against earthquakes and radical structural movement.
    The custom-fabricated high density... Read More
Products
Suppliers