none

CUTTER GETS THROUGH THREADED RODS WITHOUT SHREDDING THREADS

11-05-2017
by 
in 

New from Stainelec Hydraulic Equipment, the DW-400 manual hydraulic threaded rod cutter helps operators to cut threaded rod without damaging the thread. The flexible cutting tool can be used in both factory and on-site environments.

The threaded rod cutter cuts cleanly on both sides of rod enabling nuts to be screwed on either side and produces no sparks when cutting the material.

The DW-400 threaded rod cutter is extremely reliable, powerful and easy to use and has the ability to cut M8, M10, M12, W3/8, W1/2, 3/8 UNC and 1/2 UNC mild steel and stainless steel hooker rod (all thread).

The unit features a locking pin system that enables the user to switch and change cutting dies in seconds. The DW-400 is designed and precision manufactured in Japan to the highest international standards.

Stainelec Hydraulic Equipment
02 4871 2121
www.stainelec.com.au

 

Related news & editorials

  1. 19.07.2019
    19.07.2019
    by      In
    Requirements from clients have resulted in the production of 1 x 1m Vesconite Hilube polymer wear plates measuring 25mm and, more recently, 40mm in thickness.
    Vesconite Bearings’ technical sales consultant Eddie Swanepoel has been instrumental in translating clients’ requirements into new extruded... Read More
  2. 19.07.2019
    19.07.2019
    by      In
    The way to a ready-to-connect e-chain is now even quicker and easier with the new online igus e-chain expert. With the aid of this free and accessible online tool, users can design their e-chain systems using a smart phone, tablet or computer. Whether an unsupported, gliding or hanging application... Read More
  3. 19.07.2019
    19.07.2019
    by      In
    Machine or equipment failure causes a lot of trouble for operators: packaging equipment comes to a standstill or a wind turbine no longer turns. igus has therefore developed the world’s first intelligent plain bearing, which detects wear in extremely stressful applications in advance and sends a... Read More
  4. 19.07.2019
    19.07.2019
    by      In
    Deep drilling rigs with top drive systems are used in the oil and gas industry. To guide cables in these systems, manufacturers and operators have so far been using so-called ‘service loops’. However, these often create problems: the cables have no guidance or defined bend radius, and can slip into... Read More