none
none

Safe efficient pipe cutting is easily performed

Pipes made of steel, cast iron and other materials are usually cut with dangerous, imprecise angle grinders or heavy and unwieldy pipe cutting machines. Slow, labour-intensive manual pipe cutters are also commonly used. 
 
plumBOSS exactCUT

The fastest, easiest, safest way to cut pipes.
Pipes made of steel, cast iron and other materials are usually cut with dangerous, imprecise angle grinders or heavy and unwieldy pipe cutting machines. Slow, labour-intensive manual pipe cutters are also commonly used.
The innovative new PLUMBOSS exactCUT System essentially resolves all the problems associated with pipe cutting.

A finished surface ready for installation
PLUMBOSS exactCUT attaches to a pipe firmly. After attachment, the blade is always in the correct position automatically and does not need to be guided. The blade chips through the pipe rather than grinding it. This creates burr-free cut surfaces that are ready for jointing. Also, the ExactCUT does not generate dust or dangerous sparking.

Superior work comfort
The entire weight of a PLUMBOSS exactCUT rests on the pipe being cut, so using it is easy and safe, even in tight spaces. Only about a metre of working room is required.

Heavy pipes need not be lifted onto a work table, but can be cut at floor level. During operation, the saw is firmly attached to the pipe and cannot work itself loose from the operator's grasp.

Nor does it need to be supported or guided. Cutting small diameter pipes to size is effortless and quick on a work table, too.

No fire hazard or collateral damage
The chips produced by a PLUMBOSS exactCUT saw cool quickly and fall in the immediate vicinity of the cutting site without causing damage, even to sensitive surfaces. Minimal protection of the surrounding area is therefore required. The ease of use also improves work safety; no special skills or long-term training is needed to operate PLUMBOSS exactCUT smoothly.

Versatile, handy and quick
PLUMBOSS exactCUT pipe saws can cut a very wide range of sizes. Model PEC170 can be used to cut pipes with an outside diameter of 15–170 mm. Model PEC170E has the same cutting range, but is more powerful, and the rotational speed of the blade can be adjusted according to the material being sawed.

Model PEC200 can be used for all pipes with an outside diameter of 15–200 mm, and model PEC360 for all pipes with an outside diameter of 75–360 mm. PLUMBOSS exactCUT saws are suitable for cutting all types of pipe materials.

The PLUMBOSS exactCUT System is the fastest system on the market; for example, it takes about 35 seconds to cut a DN 100 cast iron pipe with an ExactCUT PEC170 using the Diamond blade. Switching blades on a PLUMBOSS exactCUT is simple and quick.
 
 
Request information about this News from PLUMBOSS AUSTRALIA